Bring the project in the shop.
Front deck view.
View from the transom.
Rear view of the hull upside down.
Transom planks removed.
Rear starboard view of side planks removed.
Front starboard view of planks removed.
Port front view of side planks removed.
Rear port view of planks removed.
Removing the second plank down from the chine on the starboard side.
Removing the second plank down on the port side.
Removed the fasteners from the side frames to the top plate. Epoxied the frames to the top plate and used new fasteners.
Epoxying new fasteners in place.
Adding new transom battens.
New transom batten slots installed.
New transom battens installed.
Rear port view of side battens removed.
Front port view of side battens removed.
Front starboard view of side battens removed.
Rear starboard view of side battens removed.
Fitting the plywood on the port side.
Rear starboard view of plywood fit.
Front starboard view of plywood fit.
Front port view of plywood fit.
Rear port view of plywood fit.
Coating the inside of the plywood with epoxy.
Plywood coated and sanded ready to install.
Appling epoxy to the hull so the plywood can be installed.
Appling epoxy to the plywood before installing.
Rear starboard view of the plywood installed.