Starboard front view.
Starboard rear side view.
Rear view.
Rear deck.
Engine wiring and plumbing disconnected so engine can be removed.
Engine hatch removed and engine ready to be removed.
Engine being removed.
Engine removed from boat.
Boat ready to go up side down.
Rear view of hull up side down.
Front view of hull up side down.
Front view of bottom removed.
Port rear view of bottom.
Starboard rear view of bottom.
Laminating new transom bottom frame.
Starting to remove old bottom frames.
Front port view of old frames removed.
Installing new frames.
Front starboard being replaced.
Front starboard with some new frames installed.
Port front with some new frames installed.
Removed bottom transom plank.
More starbard frames removed and new frames installed.
Port front view.
Port rear view of new frames installed.
Starboard rear view.
Chine removed starboard side.
Chine removed port side.
Chine epoxied in place starboard side.
New section of chine installed starboard side.
Old transom bottom frame removed.
New laminated transom frame and rear corners installed.
Starboard view of new transom frame.
Old breast hook and stem removed.
Starboard view.
New breast hook and stem installed.
Starboard view of new stem.
Sealing new frames with epoxy.
Front port view of new keel installed.
Starboard rear view of new keel installed.
Port rear view of new keel installed.
Coating the inside of the plywood with West System epoxy before we fit the bottom.
Port rear view of the first layer of plywood fit and ready to epoxy in place.
Port front view of the first layer of bottom.
Starboard rear view of the first layer of bottom.
Starboard side glued down with West System epoxy and held in place with tempory fasteners.
Starboard rear view of first layer of bottom glued in place.
Front view of first layer of bottom glued in place.
Front view.